Here are all our Automotive Tech Tip School segments. As you enjoy each one, make sure to click the "Like" button before every session is finished and also don't forget to subscribe to our YouTube Channel. It's all free!
Thanks in advance from Burd's Garage!
Session 1 - How to Remove a Freeze Plug
In this premier of our new automotive tech tip school, we demonstrate the proper way to remove a freeze plug from an engine. Class is in session!
Session 2 - Why a Motor IS NOT an Engine!
In this segment, why explain the differences between a motor and and engine, and why you should NEVER call an engine a "motor!" Class is in session!
Session 3 - How to Drain a Fuel Tank on a 86-95 Ford Fuel Injection Vehicle
Watch this before removing a fuel tank! Here we show neat trick to use the fuel pump to drain the fuel tank in a fox body Mustang fuel injected 5.0 engine. This of course only works if the fuel pump does. We did this on a 92 Mustang but the procedure should work on any 1986-1995 fuel injected Ford. And with a little homework, you can figure how to do this similar procedure on ANY vehicle. Class is in Session!
Session 4 - How an A/C Compressor Works
Here in our tech tip series #4, we give a very basic explanation in how an air conditioning compressor works. Class is in session!
Session 5 - How to Properly Remove a Harmonic Balancer
This segment shows the proper way to remove a harmonic balancer from the crankshaft of an engine. In this procedure, we use a special removal tool just for balancers. Class is in session!
Session 6 - How to Make a Paint Funnel
Here in tech tip school number 6, we show how to make a funnel so you will make less mess when pouring paint and primer from a can. We also show you how to prep the can for future use and storage. Class is in session!
Session 7 - Taps and Torques
In this 7th school session, we explain why it's important to clean and run a tap through every threaded holes before assembling components. We also cover why it's critical these bolts be torqued and in the proper sequence. Class is in session!
Session 8 - How to Properly Remove a Cylinder Head
Submitted for your education is the CORRECT way to remove a cylinder head from an engine, demonstrating the proper use of reverse torque sequences. Class is in session!
Session 9 - How to Install a Freeze Plug
Here in our tech tip school number 9, we show the proper way to install a freeze plug into an engine. Class is in session!
Session 10 - Setting Up a Paint Spray Gun
For this 10th edition of the Auto Tech Tip School, we show the how to set up a spray gun for painting an automotive door. Then we explain how to properly lay down the paint when working with complex surfaces in a door jam. Class is in session!
Session 11 - How to Make a Thread Chaser
For session 11 of Auto Tech Tip School, we show how to make a thread chaser from scratch with a few simple items laying around the shop. Class is in session!
Copyright © 2023 Metal and Roll Productions - All Rights Reserved.
Powered by GoDaddy
We use cookies to analyze website traffic and optimize your website experience. By accepting our use of cookies, your data will be aggregated with all other user data.